Fac F 300 TSV, Руководство по эксплуатации и обслуживанию

Страница: 39 / 62

36
Fig. 28a Fig. 28b
EN
EXECUTION OF THE SHARPENING
LUBRICATION
6. After completing sharpening, we
advise cleaning the wheels using a
small brush soaked in alcohol;
7. After the sharpening operation return
the sharpener to its original position.
10
.1 - Lubrication of carriage sliding guides and product holder plate
(weekly)
☞
Only use supplied oil
(Fig. 28a)
.
Only use white Vaseline oil
(Fig. 28b)
.
• Apply a few drops of lubricant o the guide rails and slide the assemblies back and
forth 3/4 times;
• Clean where necessary wiping the excess lubricant.
37
Fig. 29
EN
MOTOR BELT TENSION ADJUSTMENT
When after a given time the slicer has an unusual noise because of
the belt (30), proceed as follows:
• Disconnect the plug from the socket.
• Lift the slicer and place it on its side (figure “29”).
☞
Make sure that the slicer is stable
and can not inadvertently fall.
• Unscrew the pins (4).
• Loosen the screw (31) and remove the cover (32).
• Loosen the nut (33) a few turns.
• Rotate the belt tensioner (34) until obtaining a belt optimal tension (30);
• Retighten the nut (33) then reassemble the carter (32), the screws (31) and the
feet (4).
☞
Do not over-tighten the belt.
In the rotation, the engine could force and the belt may
be damaged.
Only for personnel authorized by the manufacturer
4
32
31
4
30
33
34
4
4
30
4