Fac F 300 TCV, Руководство по эксплуатации и обслуживанию

Страница: 35 / 62

32
Fig. 24
EN
SLICER CLEANING
7
.6b - Product tray underplate and
carriage cleaning
• ONLY for “TCV” versions)
• Move the carriage (7) close to the
operator and lift the product tray until
it reaches rest position.
• Clean with a damp cloth and carefully
dry.
7
.7 - Machine reassembling
Proceed in the opposite direction to what indicated in the previous operations.
7
.8 - Store the slicer
• When you finish using it, after carefully
have cleaned all the components (as
described in the previous sections)
be sure to bring the graduated knob
back to “
0
”.
• Is advised to cover the slicer with a
towel to protect it from dust.
If it is not intended to use the slicer
for some days, store it in a sepaired
and dry place.
MAINTENANCE
8
.1 - Generalities
In addition to the above-mentioned cleaning operations, you should also perform routine
maintenance in order to guarantee the slicer’s operating efficiency over time.
7
33
EN
MAINTENANCE
The operator may perform the following maintenance operations:
• Blade sharpening: periodically (periodicity and duration depend obviously on the
equipment use; working times and processed material type).
• Lubrication of carriage sliding guides: weekly.
• Lubrication of pusher sliding bar: weekly.
• Visual check of the power cord and of the gland on the machine’s base
conditions: periodically.
The maintenance operations must be performed always
after disconnecting the machine from the power network
and, if it’s not specifically necessary another position,
with the slice thickness regulation knob on ‘0’.
The maintenance operations to be entrusted to personnel authorized
by the manufacturer are the following:
• Blade replacement;
• Sharpener’s emery-wheelss replacement;
• Motor belt tension regulation;
• Motor transmission belt replacement;
• Underbase wiring’s components replacement;
• Structural parts repair, underbase components repair.
8
.2 - Blade sharpening
Accurately clean the machine as indicated in the previous paragraphs before
proceeding in the operations.
Sharpening can be performed up to a reduction of 12
mm of the blade’s diameter nominal. Over that value
IS MANDATORY TO CHANGE THE BLADE entrusting
the operation ONLY to personnel authorized by the
manufacturer.