16. Rotate the rear of the pipe with the two bolt flange up to
the factory flange and install the hardware. Torque the two
bolt flange and clamp to 37 ft-lbs.
SEE FIGURE 19.
17. Use a paint pen and mark the inside of the lower link arm
pockets as shown in the photos (cut will need to flush with
the inside mount, not the frame itself). Use a sawz-all or
a die grinder with a cut off wheel and remove the outside
of the pocket. Use an angle grinder with a sanding disc to
sand the cut area of the pocket. Paint all bare metal areas.
SEE FIGURE 20-25.
9 of 31
FIGURE 22
FIGURE 24
FIGURE 19
FIGURE 20
FIGURE 21
FIGURE 23
CUT THE POCKET FLUSH WITH THE OUTER MOUNT
CUT THE POCKET FLUSH WITH THE OUTER MOUNT
