Passenger Side Shown
18.
Locate the factory brake hose from the frame to the rear
axle. Remove and discard hose. Locate the Fabtech rear
brake hose FT50035 and FTT79 brake hose clip. Slide the
new brake hose through the factory bracket and attach the
brake hose to the hard line on the frame. Using the supplied
brake hose clip FTT79, attach the brake hose to the bracket.
Then attach it to the hard line on the axle using the factory
hardware. SEE PHOTOS BELOW ON IN NEXT
COLUMN.
Hose needs run down from factory hard line and parallel the frame
19.
Locate the factory bottom hole on the e-brake cable retainer
for the driver’s side. Measure down 2” and drill a 9/16”
hole and insert the driver’s side cable. SEE PHOTO
BELOW.
20.
Route the passenger side cable over the top of the leaf
spring and then over the top of the muffler hangers and
insert into the retainer.
bend hard
line to fit
properly
around the
weld on trac
bar bracket
Drill 2” below factory
hole for the driver’s
side cable
