10.
Locate FT20292 Trac Bar Bracket, FT20307 Trac Bar
Bracket Support, and the 7/16” & 9/16“ hardware. Position
the trac bar bracket into the factory mount on the axle and
install with the factory bolt and hardware. Leave loose.
Locate the two factory holes just forward of this mount,
Using a drill with a 7/16” bit, drill these two holes out to
7/16” (carefully bend the brake line back from the inner
hole). Position the support bracket over the two new holes
and install with the 7/16” x 2 ¼” bolts and hardware. Insert
the 9/16” x 4” bolt into the trac bar bracket and support
bracket (tighten just enough to make the bracket and
support make contact, over tightening without the trac bar
installed will collapse the bracket) Torque the 7/16” bolts to
50 lbs. SEE PHOTOS BELOW AND IN NEXT
COLUMN
11.
Using a drill with a 7/16” bit, drill the hole on the new trac
bar bracket to the factory mount. Use 7/16 x 1 ½” bolt and
hardware to attach the bracket to the mount and torque to
50 lbs. SEE PHOTOS BELOW
Provided
9/16” x 4” Bolt
Factory Bolt
