
806 Montana Ave. El Paso, TX 79902
fablabelpaso.org
915.209.2656
Mendel 3D Printer
ABOUT
Welcome, new user! Mendel is an open-source Cartesian 3D printer. It is part of
the RepRap line of self-replicating 3D printers. It uses fused deposition modeling
to build up three-dimensional objects by injecting thin layers of melted plastic.
SPECIFICATIONS
T
ype: Cartesian printer
Repeatability: better than 0.03 mm (30 micron)
Build volume: 200 mm x 200 mm x 160 mm
SAFETY GUIDELINES
1.
Please carefully read all the instructions before attempting to operate the
3D printer.
2.
NEVER
operate or test the 3D printer without proper ventilation in the area
3.
NEVER
touch the hot end of the printer. It is usually around 200°C and will
cause severe burns.
PRECAUTIONS
1.
DO NOT
make
any
modifications to the Mendel or safety features of the
Mendel. Doing so is strictly prohibited.
2.
DO NOT
attempt to use any other type of filament or print material other
than what is provided or approved by the staff.
3.
DO NOT
place hand or any other body part in the print area.
4.
AVOID
breathing near the hot end where the plastic is being melted.