Faber STILO DX/SP A90, Инструкция по эксплуатации

Страница: 8 / 28

EN
8
8
INSTALLATION
Wall drilling and bracket fixing
• Draw a vertical line on the wall on the right or on the left side depending on the hood model,
at 200 mm (90 cm hood version) or at 350 mm (120 mm hood version) taking as a reference
point the centre of the hob. Start the line from the ceiling or from other upper limit and
finish it at the 650 mm distance from the hob. This line is needed when aligning the
brackets.
• Place the
7.2.1
bracket, as indicated, at 1-2 mm from the ceiling or from other upper limit
aligning its central point on the vertical reference line.
• Draw the central points of the bracket holes.
• Place the
7.2.1
bracket, as indicated, at X mm under the first bracket (X= upper chimney
height) aligning its central point on the vertical reference line.
• Draw the central points of the bracket holes.
• Draw the reference point, as indicated, at 116 mm from the vertical reference point and at
970 mm above the hob.
• Repeat the same procedure on the opposite side.
• Draw the reference point, as indicated, at Z mm (Z= see the table) from the vertical
reference point and at 690 mm above the hob.
• Drill ø 8 mm the marked points.
• Insert the
11
plugs into the holes.
• Fix the brackets using the
12a
screws (4,2 x 44,4 ) supplied with the hood.
• Screw the 2 12a screws (4,2 x 44,4), supplied with the hood, in the hood body fixing holes.
It is necessary to leave a 5-6 mm gap between the wall and the screw head.
Cappa Y Z
90 cm 200 565
120 cm 350 830
7.2.1
970
X
1÷2
Y
116
650 min.
116
Y
11
12a
690
Z