Faber Solido FCH 32, Инструкция пользователя

Страница: 5 / 16

5
3PCLIOBMR320SD
- the ground wire is 2 cm longer than the other cables;
- the system ratings meet the ratings indicated on
the identification plate fixed on the lower part of the
worktop;
- the system is fitted with efficient ground wires in
accordance with the laws and current standards.
Grounding is mandatory by law.
If the domestic appliance is not supplied with a cable
and/or suitable plug, use material suitable for the
absorption value indicated on the identification plate
and the operating temperature (Fig.5).
If wishing to make a direct connection to the mains, an
omnipolar switch must be installed with a minimum 3
mm opening between the contacts and appropriate for
the load indicated on the plate and in accordance with
current standards (the yellow/green ground conductor
must not be disconnected by a switch). When the
appliance has been installed,the omnipolar switch
must be easily reachable.
USE AND MAINTENANCE
MAINTENANCE
Remove any residues of food and drops of grease
from the cooking surface by using the special scraper
supplied on request (
Fig.7
)
Clean the heated area as thoroughly as possible using
suitable products, and a cloth/paper, then rinse with
water and dry with a clean cloth.
Using the special scraper (optional) immediately
remove any fragments of aluminium and plastic
material that have unintentionally melted on the heated
cooking area, or residues of sugar or food with a high
sugar content (
Fig.7
). In this way, any damage to the
cooktop surface can be prevented.
Under no circumstances should abrasive sponges, or
corrosive chemical detergents, such as oven sprays or
stain removers, be used.
WARNING:
STEAM CLEANERS MUST NOT BE USED.
USE (
Fig.8
)
Set the power wanted with the command handle,
rotating it clockwise or counterclockwise, knowing that
the highest number corresponds to maximum power.
The indicator lights up when:
• At least one element is operational
à
.
• The temperature at the point indicated is greater than
50°
à
.
DISPOSAL OF OLD ELECTRICAL APPLIANCES
The European Directive 2002/96/EC on Waste
Electrical and Electronic Equipment (WEEE),
requires that old household electrical appliances
must not be disposed of in the normal unsorted
municipal waste stream. Old appliances must be
collected separately in order to optimise the
recovery and recycling of the materials they contain and reduce
the impact on human health and the environment. The crossed-
out dustbin symbol on the product reminds you of your
obligation regarding separated waste collection. Consumers
should contact their local public service or their local dealer for
more information on the correct disposal of exhausted
household appliances.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR
EVENTUAL DAMAGES CAUSED BY BREAKING THE ABOVE
WARNINGS. THE WARRANTY IS NOT VALID IN THE CASE
OF DAMAGE CAUSED BY FAILURE TO COMPLY WITH THE
ABOVE-MENTIONED WARNINGS.
GLASSCERAMIC HOB
User instructions
GENERAL INFORMATION
Carefully read the contents of this leaflet since it
provides important instructions regarding safety of
installation, use and maintenance.
Keep this leaflet for possible future consultation.
All the operations relating to installation (electrical
connections) must be carried out by specialised
personnel in accordance with current regulations.
SAFETY WARNINGS
(Fig.6
)
It is recommended to use flat-bottom pans with a
diameter equal to or slightly larger than that of the
heated area.
Do not use pans with a rough base in order to prevent
scratching the heat surface of the cooking hob. This
appliance is not suitable for use by children or persons
requiring supervision.
IMPORTANT
- Avoid spilling any liquid, therefore to boil or heat
liquids, reduce the heat.
- Please ensure when the appliance is turned on, that
there are no empty pots left on top.
- When you have finished cooking, switch off the
relevant heating element with the command indicated
below.
h
WARNING
h
If the surface of the hob is cracked, turn off the
appliance and disconnect from the electrical main in
order to avoid any possible electric shocks.
INSTALLATION INSTRUCTIONS
These instructions are for a specialized installer and
are a guide for the installation process, regulations and
maintenance in accordance with the law and current
standards.
If the built-in oven or any other appliances that produce
heat, need to be installed directly underneath the
cooking hobs in ceramic glass, IT IS NECESSARY
THAT THE APPLIANCE (oven) AND THE COOKING
HOBS IN CERAMIC GLASS ARE ADEQUATELY
ISOLATED .
POSITIONING
The domestic appliance was built in order to be
encased on a work surface, the way it is illustrated in
the graph (
Fig.1
).
Predispose sealing material along the whole perimeter
Fig.4
(see the dimensions of the cut on
Fig.1
).
This operation is necessary to avoid any liquids
penetrating the worktop, as it is not possible to
guarantee that the top, the glass and their connection
are completely flat.
Lock the domestic appliance into place with 4
supporters, keeping in mind the width of the surface
(
Fig.2
).
If the lower part of the appliance after installation,
is accessable via the lower part of the furniture, it is
necessary to mount a separating panel keeping in mind
the distances indicated (
Fig.3
) if the appliance is being
installed underneath an oven, this is not necessary.
ELECTRICAL CONNECTIONS (
Fig.5
)
Before making the electrical connections, check that:
EN