Faber Opti-V Fire, Руководство по установке

Страница: 8 / 12

Opti-V Fire : PGF 20
UK
Contents of Carton
•
Opti-V Fire Model PGF20
•
Remote control and batteries (AAA type)
Important Safety Advice
When using electrical appliances, basic precautions should
be followed to reduce the risk of fi re, electric shock, and
injury to persons, including the following:
If the appliance is damaged, check immediately with the
supplier before installation and operation.
Do not use this appliance in the immediate surroundings of
a bath, shower or swimming pool.
Means for disconnection must be incorporated in the fi xed
wiring in accordance with the wiring regulations.
Do not use outdoors.
In the event of a fault switch off the appliance.
Switch off the appliance when not required for long periods.
If the supply cord is damaged, it must be replaced by a
special cord or assembly available from the manufacturer
or its service agent.
Warning - No naked fl ame sources, such as candles, should
be placed on this apparatus.
Warning - The appliance shall not be exposed to dripping
or splashing and that no objects fi lled with liquid, such as
vases, shall be placed on the apparatus.
Warning - this appliance is of Class I construction and must
be connected to a mains outlet with protective earthing
connection.
Electrical
WARNING – THIS APPLIANCE MUST BE EARTHED
Do not switch the appliance on until properly installed. Please
read all the safety warnings and operating instructions.
Installation
Warning.
Do not connect the appliance until properly fi xed to a secure
base and the instruction leafl et is read fully.
At installation of the appliance, care must be taken not to
damage any cables that may be concealed in the wall.
Please be careful while drilling the holes.
These models are designed to be permanently fixed
for optimum viewing of the display screen see
Fig.2a and 2b .
Dimensions indicated * are recommended fi xing dimensions
from fl oor to underside of the wall aperture - 65cm for viewing in
a seated position and 110cm for viewing in a standing position.
The outline of the chassis and the position of the electrical
socket are shown as dotted outlines in
Fig.4. Please consult
with a qualifi ed electrician for appropriate wiring requirements.
Operation: -
The power ‘ON’ switch ( ‘O/I’ see Fig.3 ) must fi rst be switched
‘I’ to operate the appliance.
The ‘Opti-V’ logo will appear for about 3 seconds before the
fl ame picture starts.
Note: The user may notice a blank screen for approximately
5 seconds, every 30 minutes. This is normal and should not
be a cause for concern.
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
Manual Control Operation: -
The manual controls for the screen are located at the inner top
left hand side of the appliance above the glass.(see
Fig.3 ).
The appliance Power switch ( ‘O/I’ see Fig.3 ) may be used
to switch the appliance off ( ‘O’ ) when it is not required, for
example, overnight or for long periods, to avoid energy
wastage.
The standby button ( ) is located just below the mains switch.
Remote Control Operation: -
The remote control may be operated once the appliance is
switched
‘I’ (‘I’ see Fig.3 ). A red light will indicate when the
appliance is in standby mode. (See Fig.4 ) Aim the remote
control at the screen (I.R. sensor is indicated in Fig. 4 ). The
audio volume may be adjusted up or down by pressing the
volume control buttons ( + and -). For installing or replacing
the AAA batteries into the remote control - see
Fig. 5 .
NOTE - Use Alkaline batteries only.
Batteries should not be exposed to heat such as sunshine,
fi re and the like.
Attention should be drawn to the environmental aspects of
battery disposal.
Maintenance
WARNING – ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE.
To disconnect from mains - set the mains switch to ‘ O ’. The
mains (power) switch is located at the top left hand side of the
appliance above the manual controls - see
‘O/I’ Fig.3 .
Mians switch shall remain readily operable.
Techical Information:
100-240V ~ 50/60Hz
Power consumption 64W
Stand-by Power 1W
4
Cleaning
For general cleaning use a soft clean duster – never use
abrasive cleaners. The glass screen should be cleaned
carefully with a soft cloth. DO NOT use proprietary glass
cleaners.
Warranty and Service
For service and warranty of the product log onto the website
http://www.gdbservice.com/
select Faber and select ‘Electric’. Select model Opti-V Fire
PGF10. The series number of the product can be found on
the label on the right hand side of the product above the glass.
Please retain your receipt as proof of purchase.
Recycling
For electrical products sold within the European Community.
At the end of the electrical products useful life it
should not be disposed of with household waste.
Please recycle where facilities exist. Check with
your Local Authority or retailer for recycling advice
in your country.