Faber MatriX 1050/500 I, Руководство по установке

Страница: 15 / 44

Installation manual MatriX 1050/500 I,II,III H & MatriX 1050/650 I,II,III H
15 < < < <

Disassemble the front glass (fig. 3.3).
For replacing the glass repeat the steps in reverse
order. (If necessary, use the tool provided to pull
the "C" frame back down, see fig. 3.9).

Please note!
Avoid fingerprints on the glass, these are no
longer removable once the fire is used.
MatriX III H:

Place the suction cups on the glass and
slide frame “C” upwards (fig. 3.4).

Disassemble the front glass (fig. 3.5).
For replacing the glass repeat the steps in reverse
order. (If necessary, use the tool provided to pull
the "C" frame back down, see fig. 3.9).

Please note!
Avoid fingerprints on the glass, these are no
longer removable once the fire is used.
5.2 Side glass
For cleaning only it’s not necessary to remove the
side glass.
MatriX II H and III H:

First, disassemble the front glass (section
5.1).

Disassemble the glass strip at the top
(fig. 3.6 and 3.7).

Place a suction cup and disassemble the
side glass (fig. 3.8).
For replacing the glass repeat the steps in reverse
order.

Please note!
Avoid fingerprints on the glass, these are no
longer removable once the fire is used.
6 Placing decoration material

Attention!
It is not allowed to add other or more decora-
tion material in the combustion chamber.
Scan the QR code for a clear video instruction on
decorating the burner:
Keep the included decoration instruction card
close.
Chapter 17 provides an overview of the complete
log setup.
6.1 Switching on HPL module (optional)
To get the right glow effect, the HPL module must
be switched on at 100% intensity.
Make sure the ITC-V2 App is connected to the fire,
see fig 1.9a.

Switch on the glow effect, see fig 1.9b.

Click on the “flame” in the circle, see fig.
1.9f.

Click on the “settings” in the circle, see fig.
1.9g.

Set “Wood glow” and Ash bed glow” to
maximum, see fig. 1.9h.
Tip:
Regularly check the glow effect on the wooden
logs while decorating.
6.2 Installing HPL light guides
Insert the light guides through a slotted opening of
the burner plate into a matching recess in the bot-
tom, see section 16.2 and fig. 4.0.
With LED spot G two light guides must be placed in
one recess, see chapter 16.1, 16.2 and fig. 4.1.
When the light guide is placed correctly, light will
shine from the top side of the glass. If this is not
the case, the light guide must be repositioned.
6.3 Creating ash bed

Spread the glass granules over the entire
bottom plate, with a slightly increasing
thicker layer towards the center burner.

Attention!
Keep some glass granules for correction later
on.

By simultaneously placing (large) chips in
front of the light guides (standing be-
tween the light guide and the glass gran-
ules), this can be largely hidden from
view. Cut or break the chips so that they
do not protrude higher than the light
guide itself, to the detriment of the glow
effect on the logs. (See instruction video!)

Divide the grey mini chips from the center
over the glass granules.