Faber Honest, Руководство по установке

Страница: 9 / 24

> > > > 8
4. elbows and bends at the transition of horizontal to vertically are not to be
counted
5. the wall mounted terminal counts for 1 meter
3.2.1 Terminal position
Verify if the required terminal position meets the local installation regulations regarding
disturbance, good functioning and ventilation:
ƒ The terminal must be located so that the outlet is not obstructed.
•
Terminals located close to shared walkways, footpaths etc. could be subject to
legal constraints and this should be pointed out to the customer before installation.
If in any doubt about flue location advice should be sought from local building
control, or if appliance-related, from the manufacturer including wherever possible
a dimensioned sketch
•
Avoid locating the terminal in close proximity to plastic materials such as gutters or
other combustibles. If this is unavoidable then a suitable deflector should be made.
Some important requirements for a good functioning, the wall-mounted terminal has to be
at least 0,5 m off:
o
Corners of the building
o
Below eaves
o
Balcony's etc.
o
The roof mounted terminal has to be at a distance of at least 0.5 meters of
the sides of the roof, excluded the ridge
3.2.2 Using an existing chimney as air inlet
You can connect the appliance onto an existing chimney. The existing chimney then
functions as air supply, where a flexible stainless steel liner(100 mm) performs the flue
function.
For further information for using an existing chimney:
The manual is included in the chimney connection set.