Faber e-MatriX 800, Руководство по установке

Страница: 11 / 20

Installation manual e-MatriX 800/1600 ST
11 < < < <

Remove the decoration set;

Lift the bottom plate in the middle and let
it rest carefully at the front of the fire. See
fig. 1.2.

Loosen the plug connection, for this press
the retaining clip of the plug. Now remove
the bottom plate.
Install LED bottom lighting

Lift the bottom plate in the middle and let
it rest carefully at the front of the fire. See
fig. 1.2.

Insert the plug into the correct connector
of the terminal block (see fig. 2.0-EE and
1.2) and carefully place the bottom plate.
(Check that the cable will not block the
outflow opening (fire opening) of the En-
gine).
4.5 Test mode
Do a performance test (see chapter 7) and check
all water connections for leaks, before installing
the decoration set and closing the door.
Functional test via the ITC-V2 app
(Only possible in dealer setting).
Make sure the ITC-V2 app is connected to the fire.
Navigate to: Menu -> Diagnostics / Test mode and
push “Activate”, see fig. 4.0 to 4.3.
The Engine can be tested for function.
All components are also checked by a self-test in
the normal starting procedure.
Any error messages are displayed in the App.
Click on the "exclamation mark" symbol at the top
left of the screen for additional information about
the notification.
4.6 Built-in structure and ventilation
requirements

The construction may not rest on the fire.

Take into account the thickness of any fin-
ishing layer!

Keep a minimum distance of 10mm be-
tween built-in frame and false chimney
breast when using combustible material,
see fig. 1.4.

Take into account a minimum distance of
2mm due to expansion of the fireplace,
see fig. 1.4.
Ventilation

The e-MatriX needs a minimum free space
of 50mm above the fire.

The e-MatriX needs a minimum ventila-
tion of 210cm² underneath the fire.
Glass doors
See fig. 1.1, provide service from this side.
Opening glass doors
The doors are equipped with snap locks.

Press the door gently until a click is heard.
The door is now unlocked and will be
pushed open slightly;

Open the door further by hand.
Closing glass doors
The doors are equipped with snap locks.

Close the door and push it until you hear a
click. The door is locked now.
Placing decoration set

Please note!
To get the right glow effect, the (optional) bot-
tom lighting must be switched on at 100% in-
tensity.
Make sure the ITC-V2 App is connected to the fire,
see fig. 5.0.

Switch on the glow effect, see fig. 5.1.

Click on the “flame” in the circle, see fig.
5.1.

Click on the “settings”, see fig. 5.2.

Set “bottom lighting” to maximum, see
fig. 5.3.
6.1 Log set
See the included decoration instruction card or
Chapter 11:

Please note!
Placing the logs is a meticulous job, this deter-
mines the flame distribution.
The outflow openings may not be completely
covered.

Divide the (mini)-chips over the bottom.

Place the wooden logs.

Apply the ash material. Do not let any
decoration material fall into the outflow
(fire) opening.
Fine tuning of the glow bed
By placing the decoration chips close together you
create a real glow bed.