Faber CRISTAL, Руководство по установке

Страница: 6 / 12

4. Determine the proper cutouts for the ductwork. Make
all necessary cuts in the walls or cabinets for the ductwork.
Install the ductwork before mounting the rangehood.
5. The Cristal attaches to the cabinet through a unique
mounting system. Toggle arms illustrated in FIGURE 9 located
on each side of the rangehood support the rangehood once
it is inserted into the cabinet. The mounting arms require the
cabinet bottom to be a minimum thickness to install properly.
Measure the distance from the bottom edge of the cabinet to
the floor of the cabinet. If this distance is less than 5/8", then
the wood spacers ( 1 " x 1" x 5" ) must be used under
the toggle arms on both sides of the rangehood. Mounting
arms adjust for cabinet bottom thickness between 5/8" to 2
1/8".
6. Determine and make the proper cutout for the Power
Supply Cable. Use a 1 1/4" Drill Bit to make this hole. Run
the Power Supply Cable through the wall or cabinet. DO NOT
turn on the power until installation is complete. Use caulking
to seal around the wire opening.
INSTALL THE RANGEHOOD
1. Remove the unit from the carton and place on a flat
surface for assembly. Make sure to cover the surface to
prevent accidental damage. Remove all parts including the
backdraft damper, 2 screws, and literature package before
discarding the carton.
2. Open the glass screen and remove both grease filters
from the unit and set aside.
3. Remove the field wiring compartment cover inside the
rangehood. Using a flat blade screwdriver, remove the ap-
propriate wiring knockout for the power supply cable.
4. Attach the backdraft damper using the two Phillips head
screws supplied with the damper.
5. Lift the rangehood into the cabinet cutout. Mounting
arms should overlap the cabinet bottom or wood spacer
blocks. Feed the Power Supply Cable through the electrical
knockout.
6. Using a flat blade screwdriver, tighten the mounting
brackets to secure the rangehood to the cabinet bottom and
to eliminate the space between the rangehood and cabinet
bottom as indicated in FIGURE 10.
WARNING
FIGURE 9
Due to the size and weight of this rangehood, more
than one person is required to help with the installa-
tion. Failure to follow these instructions may result
in personal injury.
FIGURE 10
7. Adjust the rangehood front strip if necessary. The
mounting system is designed to facilitate proper alignment
between the cabinet and rangehood. The front strip and frame
of the rangehood will adjust up to 3/8" up or down and up
to 3/4" front to back. Do not adjust more than the specified
amount. Two adjustment screws are located on each side of
the rangehood as indicated in FIGURE 11. Using a Phillips
head screwdriver, turn screws counterclockwise to loosen.
Once the front strip is adjusted, retighten the screws.
FIGURE 11
8.
Connect the Power Supply Cable to the rangehood.
Attach the White lead of the power supply to the White lead
of the rangehood with a twist-on type wire connector. Attach
the Black lead of the power supply to the Black lead of the
rangehood with a twist-on type wire connector. Connect
the Green (Green and Yellow) ground wire under the Green
grounding screw.
9. Replace the field wiring compartment cover. Replace
the grease filters.
10. Turn the power supply on . Turn on Blower and Light.
IF THE RANGEHOOD DOES NOT OPERATE:
• Check that the circuit breaker is not tripped or
the house fuse blown.
• Disconnect the power supply and check that the
wiring connections have been made properly.
Version 11/98 - Page 6
!