Faber CLASSICA PLUS CLPL30SSV, Инструкции по установке; Информация по использованию и уходу

Страница: 13 / 44

13
EN
77
INSTALLATION
Fitting the Hood canopy
BEFORE FITTING THE HOOD TO THE WALL UNIT, PROCEED AS FOLLOWS:
• Disconnect the wires to the Commands at the connectors.
• Disconnect the wires to the Light at the con-
nectors.
• The Hood can be installed directly on the
underside of the wall unit (Minimum 650 mm
from the Cooker Hob).
• Create an opening in the bottom of the wall unit,
as shown.
• Insert the hood until the side supports snap into
place.
• Fasten using the 10 screws 12a provided.
• Lock in position by tightening the screws
Vf
from
underneath the hood.
• Open the suction panel by turning the specific knob.
• Disconnect the panel from the hood canopy by sliding the
fixing pin lever.
• Remove grease filters.
• Screw the Frame into place
using the 6 screws 12f , re-
connect the wires to the
Commands and Light, re-
place the metal grease filter
and the Panel.
260
13
495 - 675
LED LIGHTING UNIT
• LED lights must be replaced by Faber factory authorized
service.
Cleaning metal grease filters
The metal grease filters can be cleaned in hot detergent
solution or washed in the dishwasher. They should be
cleaned every 2 months, or more frequently if use is
particularly heavy.
• Remove the filter, pushing the lever towards the
back of the unit and at the same time pulling
downward.
• Wash the filter without bending it, leave it to dry
thoroughly before replacing (if the surface of
the filter changes color over time, this will have
absolutely no effect on its efficiency).
• Replace, taking care to ensure that the
handle faces forward.
• Cleaning in dishwasher may dull the finish
of the metal grease filter.
• No water can be present in filters before
installing back in hood.
Replacing Activated Charcoal Filter
The Activated Charcoal Filters are not washable
and cannot be regenerated, and should be
replaced approximately every 4 months of
operation, or more frequently with heavy usage.
• Remove the charcoal filter by rotating it clockwise (
backwards) until it unlocks from the motor housing
and pull off sideways.
• To re-insert each charcoal filter, place up against
the side of the blower and push it inward. Then
turn the charcoal filter clockwise (forward) until it
fits into place.
• Caution: "When used in recirculation mode, to
Reduce the Risk of Fire and Shock use only
conversion kit Model FILTER 1 or FILTER1LL"