Faber Cassette L, Руководство пользователя

Страница: 26 / 40

Symptom Cause Corrective Action
The fl ame effect will
not start. Mains plug is not plugged in.
Switch A is in the ‘ON’ (I) position, but mode
Switch B has not been pressed. (See Fig.2)
Low water level.
Low voltage connector not connected
properly. (See Fig.8)
Check plug is connected to wall socket
correctly.
Press Switch B once for fl ame effect. (See
Fig.2)
Check the water tank is full and there is
water in the sump.
Check that the connector is inserted
correctly. (See Fig.8)
The fl ame effect is too
low. Flame effect control knob is set too low.
(See Fig.2)
The water in the sump may be too high due
to the drawer being opened and closed
a number of times, water tank removed
a number of times, or the fi re has been
moved.
Metal Disc at the base of Sump might be
dirty (See Fig.13)
Increase level of fl ame by turning Control
knob C to the left slowly. (See Fig.2)
If water level in the sump is more than
40mm, the sump should be removed and
emptied in the sink.
Clean the Metal Disc with the soft brush
supplied. (See Fig.13) See ‘Maintenance.’ for
a step by step procedure.
Unpleasant smell
when unit is used. Dirty or stale water.
Using unfi ltered tap water. Clean the unit as described under
maintenance.
Use tap water with a maximum hardness of
10 dH only.
The fl ame effect has
too much smoke. Flame effect setting is too high. Turn the fl ame effect Control knob C to the
right until it is at minimum and slowly turn to
the left, about ¼ a turn, at a time. Give the
fl ame generator some time to adjust before
increasing. (See Fig.2)
Main lamps are not
working and there are
no fl ames or smoke. There is no water in the tank. Follow instructions under Maintenance , ‘Fill-
ing the water tank’.
Check the plug is connected to wall socket
correctly.
Switch ‘A’ Fig. 2 is in the ‘ON’ (
I ) position.
Press switch ‘B’ Fig.2 until you can hear one
beep only, for fl ame effect.
Troubleshooting
20