IMPORTANT SAFETY GUIDE |
Your safety and the safety of others is very important.
SAFETY PRECAUTIONS
In order to help you make informed decisions about safety, we have provided the following warnings,
safety precautions, installation instructions, and other important information to alert you to potential
hazards that could hurt you or others.
Please do a job safety analysis before each task to identify potential hazards for your situation and
remove/protect against them. Use own good judgment and take your time. Check packaged materials
immediately upon arrival to ensure that all listed parts are included and undamaged.
Read and understand all warnings, safety precautions, and instructions before installing this
product.
SENSORS FIELD OF VIEW WILL BE ALTERED WITH USE OF THE REPLACEMENT BUMPER.
• Failure to observe the following warnings and instructions provided in this manual could lead to
severe injury and/or death.
• For professional installation only. Careless installation and/or operation can result in serious injury,
death, and/or equipment damage. All liability for installation and use rests with the user or consumer.
• Fab Fours, Inc. Only approves installing this product according to these written instructions with the
hardware provided. Failure to install according to these instructions will invalidate the warranty. This
includes, but is not limited to, using alternative installation methods, hardware, or materials.
• This product is for off road use only.
WARNINGS
• Always remove jewelry and wear eye protection.
• Always use extreme caution when jacking up a vehicle for work. Set emergency brake and use tire
blocks. Locate and use the vehicle manufacturers designated lifting points. Use jack stands.
• Always use appropriate and adequate care in lifting components into place.
• Always ensure components will remain secure during installation and operation.
• Always wear safety glasses when installing this kit. A drilling operation will cause flying metal chips.
Flying chips can cause serious eye injury.
• Always use extreme caution when drilling a vehicle. Always disconnect power before welding.
Thoroughly inspect the area to be drilled (on both sides of material when possible) prior to drilling,
and relocate any objects that may be damaged.
• Always use extreme caution when welding a vehicle. Thoroughly inspect the area to be welded (on
both sides of material when possible) prior to welding, and relocate any objects that may be a fire
hazard. When welding in a cab, make sure the interior surfaces are covered (e.g., welding blanket) and
a fire extinguisher is at hand.
• Always use extreme caution when cutting and trimming during fitting.
• Always tighten all nuts and bolts securely per installation instructions.
• Always route electrical cables carefully. Avoid moving parts, components that become hot, and
rough or sharp edges.
• Always insulate and protect all exposed wiring and electrical terminals.
• Perform regular inspections and maintenance on mounts and hardware.
