15
5. Install the edge trim with adhesive onto the leading
edge of the Cowl. (Figure 18)
Note: Do not stretch the seal as you apply it to the
Cowl. Doing so may cause the seal to pull away from
the sheet metal in the future.
6. The edge seal should terminate at the hook of
the Cowl on each end.
4. Loosely install both ViCowl arms to the visor
using the six (6) 3/8”-16 yellow zinc, hex cap
screws and rubber bonded washers provided in the
hardware kit. (Figure 17)
7. Trim the edge seal for fit and finish. (Figure 19)
Figure 14
Figure 17
Figure 18
Figure 19
