Installation Instructions
VI-COWL
Product Number: VC2900
2010 - 2018 DODGE 2500
Copyright 2009 Fab Fours, Inc
. Page 14 of 19
VC2900_Installation_Manual_REV_A
a.
Install and hand tighten the rubber bumpers and ½” flat washers to the
visor as shown in
Fig 10
.
b.
Install loosely the Visor trim (or light insert if purchased) into the back of
the visor using the provided 5/16”-18 stainless steel bolts, rubber bonded
washer, flat washer, and 5/16”-18 Nylock nut.
Note: The rubber bonded washer is used on the outside surface of the visor to
reduce any powder coat wear marks what would otherwise be created using regular
flat washers and visible if bolts are moved due to reassembly of visor with light
insert.
c.
Fully tighten all visor trim hardware
Fig 11
d.
Install the 1” neoprene rubber strip to the inside of both arms as shown in
Fig 11
.
Note: leave about a ⅛" reveal on the edge of the arms. This will ensure the rubber
strip doesn’t shift or show after installation.
Fig 12
