Installation Instructions
Yukon XL 1500 Winch Bumper
Product Number: H2340-H2342
Application: ’07-’12 GMC Yukon XL 1500
Copyright 2012 Fab Fours, Inc.
Page 19 of 21
H234X_REV_A-Rev.A
Figure 224 – BUMPER ATTACHMENT – VIEW FROM BOTTOM
5.
Adjust the bumper to achieve good visual alignment as follows:
1.
Adjust in/out bumper alignment with mounting bracket to frame
hardware.
2.
Adjust up/down and left/right alignment with bumper to
mounting bracket hardware
NOTE:
Fab Fours recommends a
MINIMUM
gap of 3/8” at the outer fenders and
headlights to prevent paint damage in normal operation.
6.
Tighten all fasteners fully; beginning with frame mounts. Then tighten all
mount-to-bumper fasteners.
7.
OPTIONAL:
Trim the inner fender liners to match the higher clearance of
your Fab Fours bumper. This can be done with a body saw, rotary tool, or
sharp utility knife (New blade strongly recommended).
USE CAUTION
WHEN PERFORMING ANY CUTTING OPERATION TO PREVENT
VEHICLE DAMAGE OR PERSONAL INJURY
.
8.
OPTIONAL:
Hardware and mounting provisions are provided to reattach the
inner fender liner to you Fab Fours bumper if desired. It is recommended that
vehicles that perform in severe duty environments or spend a significant
amount of time off-highway that the inner fender liner NOT be attached to the
Fab Fours bumper, as it may cause damage to the inner fender liner mounting
due to chassis flex.
