R180N / R280N
2
532082 - Rev. B
ENGLISH
Translation of the original instructions
ENGLISH
WARNINGS FOR THE INSTALLER
GENERAL SAFETY REQUIREMENTS
12. The power mains of the automation system
must be fitted with a multi-pole power switch
with a switch-contact gap of at least 3 mm. It
is advisable to use a 6A circuit breaker with a
multi-pole power switch.
13. Verify
that there is a differential switch with a 0.03
threshold upstream of the system.
14. Verify that the earthing system is perfectly con-
structed and connect the metal closing parts.
15. The safety devices (EN 12978 standard) protect
any danger zones from risks of mechanical
movement, such as crushing, dragging, shear-
ing and lifting.
16. For each system, it is recommended to use at
least one light indicator (e.g. flashing light), as
well as an adequately secured warning sign.
17. FAAC declines all liability concerning safety and
the correct operation of the automation system,
if system components not manufactured by
FAAC are used.
18. Only use original FAAC parts for maintenance.
19. Do
not modify the components of the automation
system in any way.
20. The installer must supply the user all information
concerning the manual operation of the system
in case of an emergency.
21. Do not allow children or adults to stay near the
product during operation.
22. Keep radio controls or other pulse generators
out of the reach of children to prevent the auto-
mation system from being activated involuntarily
23. Transit is only permitted when the automation
system is stopped.
24. The user must not attempt any kind of repair or
direct intervention and must only contact quali-
fied personnel.
25. Maintenance: check the efficiency of the system
at least every 6 months, especially the efficiency
of the safety devices (including, where applica-
ble, the operator thrust force) and the release
devices.
26. Anything not specifically stipulated in these
instructions is not permitted.
1. ATTENTION! It is important for the safety of
persons to follow all the instructions carefully. In-
correct installation or incorrect use of the product
could cause serious harm to people.
2. Read the instructions carefully before installing
the product.
3. The packaging materials (plastic, polystyrene,
etc.) must not be left within reach of children as
they are potential sources of danger.
4. Keep these instructions for future reference.
5. This product was solely designed and built for
the use described in this document. Any other
use, not specifically described, could compro-
mise the integrity of the product and/or be a
source of danger.
6. FAAC disclaims all liability deriving from im-
proper use or use other than that for which the
automation is intended.
7. Do not install the equipment in an explosive
atmosphere: the presence of flammable gas or
fumes is a serious safety hazard.
8. Mechanical constructive elements must be in
accordance with the provisions of EN 12604
and EN 12605 standards.
For non-EU countries, in addition to the national
standard references, the above mentioned stand-
ards must be complied with in order to achieve an
adequate level of safety.
9.
FAAC is not responsible for failure to comply with
Good Technical Practice when constructing the
closing elements that are to motorise or for any
deformation that may occur during use.
10. Installation must be carried out in accordance
with EN 12453 and EN 12445 standards.
For non-EU countries, in addition to the national
standard references, the above mentioned stand-
ards must be complied with in order to achieve an
adequate level of safety.
11. Before performing any operation on the system,
disconnect the power supply.
Содержание R180N
Страница 1: ...R180N R280N R180N R280N...
