ND1
10
732558 - Rev. D
Make sure that the frames are aligned.
Use the level to check that the device is horizontal.
Set the supplied toothed washers in place and tighten the tie rods using a T40 Torx wrench.
Proceed as described in Chapter 9.
5.5
Fixing the frame
5.4 Fixing
holes
Assemble the pieces and place them under the architrave or on the windowsill (installation on the architrave in fi gure 9).
Mark the position of the holes on the frames and drill with the appropriate bit.
Place the dowels adequate for the material on which the N1D will be installed.
ATTENTION: The quality of the fastening is essential for the device to work properly. For this, the dowels must be adequate
for the type of fastening material and 8x80 screws.
Fig. 9
Fig. 10
Содержание N1D KIT
Страница 1: ...N1D KIT N1D AUTO KIT N1D SENSO KIT...