FAAC E045, Руководство пользователя

Страница: 34 / 44

E045 34 732786 - Rev.C
ENGLISH
8.2 ALARMS
When there is an ALARM the ERROR LED will begin to flash. By simultaneously pr
and - the display will show the corresponding alarm number.
The following table contains all the alarms that can be viewed on the display.
N° ALARM Solution/Description
2 0
Obstacle on MOTOR 1 (only with
encoder)
Remove any possible obstacle on leaf 1
2 1
Obstacle on MOTOR 2 (only with
encoder)
Remove any possible obstacle on leaf 2
2 5
LOCK 1 output short-circuit Remove the cause of the short-circuit
2 8
Nr. of consecutive obstacles
exceeded during closing Remove any possible obstacle.
Should the problem persist, repeat SETUP
3 0
XF radio code memory full Cancel the radio codes.
3 1
Breach alarm
A movement was made with the automated system in
status
St
=
00
or
01
.
Perform an operation cycle.
9. TROUBLESHOOTING
Description Solution
A The board does not turn on
• Ensure that the board is receiving the 230V~
• Ensure that fuse F1 is intact
B
The gate will not open after
an OPEN pulse
• Check that the safety devices and STOP are connected
to the negative and ensure that the corresponding LEDs
are ON
• Check the photocells (alignment, engagement)
• Check that the SETUP has been completed correctly.
Repeat if necessary
C
The gate does not reverse
when the photocells are
engaged
• Check that the traditional photocells are correctly wired and
that the BUS photocell configuration is correct (if present).
If necessary, repeat the acquisition of the
BUS-2EASY
devices
D
The gate does not reverse
w h e n e n c o u n t e r i n g a n
obstacle
• Ensure that the encoders on motors are enabled
• Check the obstacle detection sensitivity
E
The gate will not close
• Check that the photocell wiring and alignment is correct
• Check that there is no OPEN signal active
• Check which function logic has been chosen (automatic
or semi-automatic)