FAAC DAAB DB411, Инструкция по эксплуатации, Страница: 3 / 12

DAAB RADIO CARD DB411 INSTRUCTION MANUAL
Revision 7 3
Installation of antenna
The DB411 is normally supplied with an internal antenna that is installed directly on the BNC connector In cases where the
range is not satisfactory, an external antenna can be fitted instead. Note the following points regarding how the antenna is to
be located.
• Locate the antenna high above the ground.
• The antenna must not be located close to other metal objects such as joists, electric cables or other antennas.
Commissioning/Coding
To prevent all hand transmitters from affecting all receivers, the hand transmitter and receiver concerned are coded together.
Each transmitter has a unique code that cannot be changed. The receiver is programmed with the hand transmitter's code by
pressing the auto-programming button (SW1) on the receiver. Each configuration is confirmed by the LEDs on the receiver.
The receiver can handle 85 different transmitter buttons.
• Code transmitter and receiver together.
1. Hold down the auto-programming button (SW1) until the yellow LED (D1) lights.
2. Press the auto-programming button (SW1) until the correct LED lights depending on which channel is to be used. (See
explanation below).
3. Now transmit using the appropriate transmitter button while the LED is lit. As long as the LED is lit, more transmitters
can be programmed.
The receiver has now registered the hand transmitter's code and the LED on the receiver flashes. When the LED has turned
off, repeat the above if more hand transmitters or other buttons are to be able to control the receiver. Check that the output
is activated in channel r001 and that the LED lights when the transmitter button is pressed. In the case of EP105, channel
C711 must be set to 1 for the r-channels to be shown.
• Clear individual transmitter buttons
1. Hold down the auto-programming button until the LED lights.
2. Now transmit with the transmitter button to be cleared. Repeat for all hand transmitters to be cleared.
3. -D3 and D4 on the radio module flash twice to show that the button has been cleared
• All programmed transmitters are cleared from the memory.
1. Hold down the auto-programming button until the LED lights. See illustration above.
2. Release the button and press it again until LED D1 flashes 3 times.
3. All programmed transmitters are now cleared.
• Memory full
If the receiver's memory is full, that is, if 85 hand transmitters have already been programmed, LEDs D3 and D4 flash 3 times
and programming is discontinued. Any hand transmitter must be cleared before it can be programmed again.
Channel 2, D2
SW1
Channel 4, D4
Channel 3 D3
Channel 1, D1