F5 BIG-IP 8950, Руководство по платформе

Страница: 17 / 56

Viewing valid media types for an interface
You can use
tmsh
to view the valid media types for an interface.
Note: This platform may not support all of the media type options that are available in
tmsh
.
1. From the system prompt, type the following to open
tmsh
:
tmsh
The following prompt displays:
(tmos)#
.
2. Type the following to navigate to the network module:
net
The following prompt displays:
(tmos.net)#
.
3. Use the following syntax to display the valid media types for a specific interface:
show running-config interface <interface_key> media-capabilities
Important: In all Gigabit Ethernet modes, the only valid duplex mode is full duplex.
The following is an example of the output you may see when you issue this command on interface 1.3:
net interface 1.3 {
media-capabilities {
none
auto
10T-FD
10T-HD
100TX-FD
100TX-HD
1000T-FD
1000T-HD
}
}
Network interface LED behavior
The appearance and behavior of the network interface LEDs on the platform indicate network traffic activity,
interface speed, and interface duplexity.
RJ45 Copper interface LED behavior
The appearance and behavior of the RJ45 network interface LEDs indicate network traffic activity, interface
speed, and interface duplexity.
Activity LED Speed LED Link
Not lit Not lit No Link
Yellow solid Yellow blinking 10Mbps, half duplex
Green blinking Yellow blinking 10Mbps, full duplex
Yellow blinking Yellow solid 100Mbps, half duplex
Green blinking Yellow solid 100Mbps, full duplex
17
Platform Guide: 8950