F2 362039 2007, Инструкция по эксплуатации

Страница: 18 / 46

20
• Check the product for damage or wear
before each use. Only use the product if it is in
perfect condition!
Assembly
Follow the step-by-step assembly instructions in
the order given.
1. Select a suitable area that is clean and
smooth and has enough room to unpack
and unfold the product. Make sure that all
the parts are included and are in perfect
condition.
2. When assembling the product for the second
time, and subsequently, check for any
damage, holes or tears and seal them as
described further on. Once you are on the
water, it is too late to repair any damage.
Assembling the paddle (Fig. B)
1. Release the locking lever (4a) on the exten-
sion pole (4).
2. Insert the paddle handle (3) into the extension
pole.
3. Extend the paddle handle out of the extension
pole to the desired length.
Note:
please refer to the section "Adjusting the
paddle length" to set the correct length of the
paddle handle.
4. Press the locking lever onto the extension pole
in order to lock the paddle handle.
5. Insert the open end of the extension pole into
the end of the paddle blade (2). The pin on
the extension pole must click audibly into the
pin-hole of the paddle blade.
Disassembling the paddle
Proceed in the reverse order to disassemble the
paddle.
Assembling the kayak paddle
(Fig. B)
1. Release the locking lever (4a) on the exten-
sion pole (4).
2. Insert the kayak paddle blade (5) into the
extension pole (4).
3. Press the locking lever onto the extension
pole in order to fix the kayak paddle blade
in place.
4. Insert the open end of the extension pole into
the end of the paddle blade (2). The pin on
the extension pole must click audibly into the
pin-hole of the paddle blade.
Inflating the board
WARNING!
• Inflate the air chambers in the correct se-
quence.
• Avoid over-inflating the air chambers, other-
wise you risk over-stretching the seams or even
splitting them.
• Operating pressure can increase when ex-
posed to the sun. Compensate the air pressure
by releasing air from the board.
• Use commercially available foot pumps or
double-action hand pumps with the appropri-
ate attachments and pressure gauge to inflate
the product.
• Do not use a compressor or compressed air
canister to inflate the product. This can lead to
damage.
• Always fully inflate the board.
• Do not inflate the board near sharp or pointed
objects, or on rough or stony ground.
• Always fully inflate each air chamber.
IMPORTANT!
• Open the valve only to inflate and deflate.
Otherwise it can become contaminated.
• The area around the valve must always be
clean and dry.
• Ensure that sand or other contaminants do not
get into the valve.
• To achieve maximum pressure, switch from
double to single action.
• Switch the lever on the air pump (7) over to
alternate between double action and single
action.
Inflation sequence
Inflate the chambers in the following sequence:
1. - inner air chamber 0.8bar
2. - outer air chamber 1.0bar
Inflating the air chambers
Important!
• The optimal operating pressure for
both air chambers is 1bar.
GB