User Manual
ECO 200
Initial Start Up
F+D
Feinwerk- und Drucktechnik GmbH
Kirchenstraße 38, D-69239 Neckarsteinach
Tel.: 06229 7000, Fax: 06229 70067
E-Mail: [email protected], Internet: http://www.fuddruck.de
5
2. Initial Start Up
2.1 Preparation of Location
Location of installation must be even and stable. Please allow sufficient room
•
to connect the cables, and
•
to operate the printer.
The printer has to be used according to the conditions of operation for which the printer was conceived.
2.2 Security Advice
•
The housing or the interior of the printer are not allowed to come into contact with liquids.
•
Before operating the printer, please make sure that your mains supply is operated at 230V~, 50 Hz or
115V~, 60 Hz.
•
In order to avoid the risk of an electric shock, do not remove the cover. The interior of the ECO 200 does
not contain any parts to be serviced by the operator.
•
Maintenance work can only be effected by qualified service personnel.
•
In case the printer is not used for a while, remove the mains plug from socket. Always remove on the
plug, never pull at the cable.
•
Interrupt operation immediately, if liquids or parts enter the interior of the ECO 200. Shut off at the mains
plug and inform qualified service personnel.
•
Before transporting the printer, all paper- and transfer ribbon rolls must be removed.
•
To drive the printer via centronic interface, the enclosed delivered cable or an equivalent printer cable
according to the IEEE 1284 specification (the single conductors are twisted two by two and twice
shielded) must be used.
•
Attention!
This is a class A device. In a residential area it can cause radio interference. In this case the
responsible person can be obliged to take the adequate measures to prevent the interferences.
2.3 Unpacking
After unpacking the printer, please check contents of the box.
•
Printer ECO 200
•
Mains Cable (DIN-Standard)
•
Centronics Cable (IEEE 1284 - specification)
•
Sample Reel of Thermal Paper
•
User Manual and Softwaremanual
•
Printer Driver with Description
2.4 Connection of Mains Cable
At the rear of the printer the connector for mains cable and the mains switch are located.
•
Switch off ECO 200 ("0" must be depressed on mains switch).
•
Connect mains cable (consider firm connection). Use earthed socket only.
•
Switch on ECO 200 („1“ must be depressed on mains switch).
