Installation
Remove all packaging material before using the new
refrigerator. This includes the foam base and all adhesive
tape holding the refrigerator accessories inside and outside.
Clean both the inside and outside of the refrigerator with
wet cloth (a little detergent could be added into the warm
water to wash the cloth and then wipe it again with the clean
water);
Prepare an independent two-pole socket with grounding
contact for the refrigerator and it shall not share a
multi-purpose socket with other electrical appliances;
Do connect grounding wire! The grounding pole of the
socket shall be provided with a reliable grounding wire.
Open the refrigerator body and take out the accessory
(decorative cover for bottom beam) and the three screws
from the instruction packaging bag; then install them into
the bottom beam as shown by the schematic diagram on the
right.
The decorative cover for bottom beam is used as ornament,
so you can choose not to install it. It won't affect the
refrigerator's performance or conditions no matter whether
you install it or not.
Transport and Placing of Your Refrigerator
Transport
Keep upright and avoid squeezing or vibration during
transport. Avoid a slant angle over 45 degree during
handling.
Avoid the door or top cap from being under excessive stress
when moving; otherwise, it may become deformed.
Placing
Place your refrigerator in a well- ventilated place and keep it
from heat source and direct sunlight. Don't place it in any
humid or wet place so as to avoid rust and weakening of
insulation effect.
There shall be a space not less than 30cm from the top of
your refrigerator and not less than 10cm from both sides or
the back of the refrigerator to the adjacent walls
respectively. This requirement is good for open and close of
the door and also for heat emission.
The refrigerator shall be placed on a flat and firm ground (if
not flat, you can use the leveling legs for adjustment).
Keep Your Refrigerator Standing
Don't connect your refrigerator to the power supply
immediately after it is placed vertically. You should keep it
standing for at least 6 hours before switching it on in order
to ensure it running well.
Make sure the power wire is not pinned by the refrigerator
or other objects so as to avoid accidents arising from power
wire faults. Please check the voltage scope of your
refrigerator against the actual power supply before
switching it on.
Attention
The refrigerator must be disconnected from the source of
electrical supply before attempting the installation of
accessory.
Don't use mechanical equipment or other methods to
accelerate the defrosting process except the means
recommended by the manufacturer.
Don't use any electrical appliances in the food storage
compartments except the model recommended by the
manufacture.
The R134a refrigerant and cyclopentane foaming material
used in the refrigerator are inflammable. All waste and
discarded refrigerators shall be placed away from naked fire
and they are not allowed to burn.
Warm Reminder: Place foods into the drawer. Do not place
any foods after removing the drawer.
