PAGE 4
f.a.l. SIRIO II ARGB
3 - INSTALLING THE PROJECTOR
The Projector should be mounted via its yoke (1) using at least two M10 size screws. Always ensure that the structure
to which you are attaching the projector is secure and is able to support a weight of SIRIO II ARGB (8.5kg). The projec-
tor yoke allows an angle adjustment of +/- 360°.
And
,
once
positioned
,
the
knobs (2) should be firmly tightened. For
safety the projector should have a secondary fixing with a safety chain to
wind
the yoke.
2
1
4 - CONNECTIONS
MAINS CONNECTION:
Please pay attention to the voltage and frequency marked on the back panel of the projector. It is recommended that
each projector is supplied separately so that they may be individually switched on and off.
It is essential that each projector is correctly earthed and that electrical installation conforms to all relevant standards.
Power consumption of the SIRIO II ARGB is 150W.
NOTE: The Earth must be connected.
DMX 512 CONNECTION:
The SIRIO II ARGB accepts digital control signal in DMX 512 format. Connection between controller and projector and
between one projector and another must be made with 2 core screened cable, with each core having at least 0.5mm
2
cross section. Connection to and from the projector is via XLR-3 plugs and sockets. The XLR’s are connected as
shown in the table below.
NOTE: Make sure that none of the connections touch the body of plug or each other. The body of the plug is
not connected anyway.
