PAGE 3
f.a.l. SIRIO II ARGB
1 - SAFE USAGE OF THE PROJECTOR
•
Disconnect power before opening.
•
Do not attempt to dismantle and modify the projector.
•
Do not allow contact with water or any other fluids, or metallic objects.
•
Do not install the projector in areas of high humidity.
•
Not allowed to be mounted directly on inflammable surfaces.
•
Keep
at
least
0
.
5
meter
distance
between
the
projector
and
adjacent
inflammable
surfaces
.
•
The
lighting
apparatus
must
be
used
only
with
its
protective
shield
.
•
Protective grill, lenses, U.V. filters should be replaced if they are visibly damaged to the point at which their effec-
tiveness is diminished, for example by becoming cracked or deeply scratched.
•
Keep at least 5 meters between the lamp and the illuminated surface.
•
Avoid direct exposure to the light from the lamp. The light is harmful to the eye.
•
The lamp reaches very high temperatures, allow at least 15 minutes for the lamp to cool completely before at-
tempting to handle it.
•
To ensure the reliability of the projector, it is recommended that the fans should be cleaned every 15 days. In loca-
tions such as discotheques the objective lens should be cleaned every week as smoke fluid can condense on it
and very quickly reduce the light output.
2 - GETTING STARTED
In this section you will find some brief steps to follow to start using immediately the projector. These few instructions are
essential for connecting and supplying the projector, but do not exhaust the several functions the apparatus is capable
to do.
You are strongly invited to read the rest of this instructions manual once installed the projector, so as to get more in-
sight and acquire full control on the fixture functionalities. For further deepening on single steps, you are send back to
the relevant section, indicated in the brackets.
Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact. Refer
to the following packing list for information on what items are included with your model. If any equipment is miss-
ing or damaged, contact your FAL dealer immediately.
Document No: FM-L2010-001-R01
SIRIO II WRGB
Instruction Manual
Model:
SIRIO II WRGB
ATTENTION
This instruction manual contains important information about the installation and use of
the projector. Please read and follow these instruction carefully.
ATTENTION
Always ensure that the power to the project is disconnected before opening the projector
or commencing any maintenance work.
1* SIRIO II ARGB
1* Instruction manual
1* Power connector
Before beginning initial setup of your SIRIO II ARGB, make sure that here is no evident damage caused by trans-
portation. In the event that the unit’s housing or cable is damaged, do not plug it in and do not attempt to use it
until after contacting your FAL dealer for assistance.
