11
Naming Inputs and Outputs and Changing Names:
Command for initial Naming or changing name of Input or Output:
Note: The system default names are:
Inputs:
Input1, Input2, Input3, Input4
Outputs:
Output1, Output2, Output3, Output4
The name can contain a dash (
– ) but NOT a space or underscore. eg. “Pond-pump” is OK
The product does not support special characters.
Command:
Change Current Input or Output Name to New Input or Output Name
(Example: Change input1 to Alarm)
(Example: Change output1 to Pump)
This command is used to change Inputs and Outputs to a new name. Names can be words
up to a total length of 20 characters, please
note
the name can contain a dash (
– ) but NOT
spaces. Once the name has been changed, the particular Input or Output is always referred
to by the
new name
(e.g. Alarm). For commands or status interrogation and the SMS-TEM-4
will respond using the new name.
Use table on page 22 to record your new Input and
Output names.
If the device you are trying to rename is not currently in the list, the system responds with:
Sorry either that device does not exist or the message format is not understood, please
check the spelling and try again
If the new name chosen does not fulfill the requirements of a name, the system responds
with:
Sorry that name is not allowed, please check that it is between 1 and 20 characters
long
If everything is ok, the system responds with:
The input name has been changed to YYYYYYYYYY
Or
The output name has been changed to YYYYYYYYYY
Change the Input Delay
(see page 22 for detailed explanation)
(You can have a delay when an Input turns either On or Off )
Command:
Change INPUT NAME on delay to XX sec or min
(Example: Change input1 on delay to 10 min)
Command:
Change INPUT NAME off delay to XX sec or min
(Example: Change input1 off delay to 10 min)
( XX can be between 1 and 99 seconds or 1 to 99 minutes )
The system responds with:
The INPUT NAME (On or OFF) delay has been set to XX (sec or min)
If XX is not between 1 and 99 or no value is entered, the system responds with:
Because no value was set the INPUT NAME (On or OFF) delay has been set to 30 secs
Ezy Switch SMS-IRR-4 Installation & Operation
