4
Method 2 Add by gateway
1. Press the function key of the gateway once to make the gateway enter device adding mode, and the LED indicator ring is in
slow-flashing white.
2. Press and hold the Button of the Sensor for 5s to make the Sensor enter network configuration mode, and the LED indicator
light is fast-flashing.
3. There will be a voice prompt reminding you that the Sensor has been added to the gateway automatically, or you can view
the addded Sensor on your EZVIZ APP.
·
If the LED indicator light is fast-flashing green for 3 mins, which means the Sensor is failed to be added to the gateway, please repeat the
above steps again.
·
If you want to delete the Sensor, please choose either of the following methods to clear the matching relationship between the Sensor and
the gateway:
-
Enter detailed page of the Sensor on your EZVIZ APP, and then delete the Sensor;
-
Press and hold the Button of the Sensor for 5s to reset and then delete the Sensor from the gateway.
Select Appropriate Location
Installation Cautions
•
Please strictly refer to the installation ways of the user manual to install your sensor.
•
To avoid the happenness of dangers, please fix the sensor securely when install it on walls or ceilings.
•
Please ensure that all components includes the sensor inside of the package are in good conditions
•
There should be multiple sensors when the length of the installation location (like ceiling) is greater than 10 meters.
•
Please install the Sensor after finish your indoor decoration, for fear that the Sensor is polluted by the environment.
•
The installation parameters are subject to EN 14604:2005/AC:2008.
•
Do not install the Sensor on the following locations:
High-humidity spaces like kitchen, water heater, bathroom;
High-temperature and pollution-prone places like stoves;
Severe convection places like air-conditioners, fans, heating outlet;
Object shelters;
Dusty, nasty places or places with many insects;
Places with a distance of less then 1.5 meters from the light;
Dead-air spaces like top of house with spire and house corners.
1� For Flat Roof
The edge of the Sensor should be at least 500mm away from any wall.
Forbidden Zone
Optimal
Installation Site
Suitable
Installation Site
500mm
Forbidden Zone
500mm
