3
c
a
b
4
a
b
c
a
b
c
d
■
Start the installation
1. Install latch
a. Insert the latch and lay the faceplate against the door edge.
Use a pencil to mark its perimeter, then take out the latch.
b. Chisel out the portion you've marked with pencil for about 5/32" (4mm) deep.
Score the area within the borders as clearly and precisely as possible.
Ensure the plate can fit flush with the door edge surface.
c. Insert the latch and tighten it with screws.
Be sure the holes for through-bolts (next to the adjustable cam) are horizontally
aligned.
d. It is not necessary to chisel the door edge for the faceplate installation if you use
the drive-in latch.
You may install it into the edge bore directly, but be sure the bevel should face
the outside assembly.
a. Half-close the door to lay the latchbolt against the door frame.
Mark the position of faceplate as an indication.
Place the strike against the door frame and mark its perimeter.
Make sure the center of strike is perfectly aligned with the center of faceplate.
b. Drill a ø1" (25.4mm) hole with 1/2" (13mm) depth on the center of strike outline.
Then use the chisel to scrape out the door frame for 1/16" (1.6mm) deep within
the traced outline.
Make sure to chisel deep enough to allow the strike to lay flush with the frame
surface.
c. Insert the strike and tighten it with screws.
Note : please use “tapping screws” for a metal door.
2. Install strike
Change Lever Handing
a. Make sure that the lock is unlocked.
(The spindle is perpendicular.) Remove the
protection sleeve of the exterior lock unit.
Rotate the exterior lever by 180 degrees and
return the protection sleeve to its original position.
b. Insert the dismantle tool into the hole on the
neck of the exterior lever and press down,
and pull the lever out at the same time. From the
interior, just remove the lever and switch the
interior and exterior levers.
c. Push in and fasten the lever. Make sure that the
lever is correctly in place, and test the lock by
turning it to make sure it's functioning properly.
Protection
sleeve
Protection
sleeve
Exterior lever
Exterior lever
Interior lever
Remove the interior lever
Use the thumb and index finger to push against the
lock body while holding and pulling the lever back.
Meanwhile, insert the dismantle tool into the hole
on the side of the lever, press down, and the
lever can be pulled out.
