E
E
Z
Z
P
P
u
u
l
l
l
l
T
T
r
r
a
a
p
p
S
S
e
e
t
t
u
u
p
p
&
&
P
P
a
a
i
i
r
r
i
i
n
n
g
g
G
G
u
u
i
i
d
d
e
e
For TRBP-02 (HW 2.5.0)
4.
Paring the remote units with a Base Station: The remote
units communicate with a base station that controls the Trap
machine. There are two options for a base station:
EZPull Target Manager: uses a card payment system. The
Card unit is typically mounted at the entrance to the Trap
field. Refer to the Administrator’s Guide of the EZPull Target
Manager for specific setup instructions.
Trap base station: located at the back of the trap house and
directly controls the trap machine. The remote units and base
station on each trap field must be set on the same unique
address code.
Follow procedure below to pair the base station with the
Remote units:
4.1.
Turn off all the remote units.
4.2.
Disconnect the Base unit from the Trap or any high
voltage source.
Warning: working while high voltage source is
connected, can be hazardous and may result in serious
injury.
4.3.
Set the Base Station in paring mode.
4.3.1.
Place a small magnet next to the magnetic
switch (looks like a red bar) on the left side of
the base station.
4.4.
The Red LED will blink for 2 seconds, then the Yellow
LED will blink rapidly and then both lights will glow
steady. Remove the magnet at once. Both Red and
Green/Yellow LEDs will flash indicating the base station
is waiting for a Pairing call from the remote.
4.5.
Set one of the remote units in Paring Mode:
Remove the rubber boot. Remove the battery door.
Remove one battery.
Press and hold the On/Off key [ ] and replace the
battery. Both lights should be on steady. Release the
key. Observe the LED indicators on the base station and
release the key.
4.6.
If Pairing is successful you will see the following light
flashing sequence: Blue, Red, Blue, Yellow followed by
slow flashing of the Yellow LED indicating normal
operation mode.
4.7.
Following a successful pairing, the remote unit should
be in sleep mode (no lights). If lights are still flashing,
remove one battery, wait 10 seconds and replace it.
4.8.
Verify pairing: Press and release the [ ] on the remote.
Observe the lights on the base station. Press and
release the “Target” [ ] key. The Blue light on the base
station should turn on momentarily.
Yellow
Blue
Red
Reed Switch