E
E
Z
Z
P
P
u
u
l
l
l
l
T
T
r
r
a
a
p
p
S
S
e
e
t
t
u
u
p
p
&
&
P
P
a
a
i
i
r
r
i
i
n
n
g
g
G
G
u
u
i
i
d
d
e
e
For TRBP-02 (HW 2.5.0)
2.
Wireless Address Setup: The remote microphone units and
base station on each Trap field must be set on the same
unique address code. The address code is made of two
numbers:
Field: The Field number is a common radio address for all the
EZPull systems on the same area. If you have 16 Trap fields
or less you do not need to change this address.
Station: The station number is the unique radio address for
communicating between all units and base station on the
same trap field.
First set the same address on all the EZPull remote units on
the Trap field and then pair with a Base Station (See below).
2.1.
Follow section 1 above to enter and work in Setup
mode.
2.2.
Changing the Station Number: Use the [ ] + [ ]
keys
combination access the Station Number adjustment.
EZPull can be set to any station number in the range 1
to 16.
2.3.
Changing the Field Number: Use the [ ] + [ ] keys
combination to access the Field Number adjustment.
EZPull can be set to any Field number in the range 1 to
14.
3.
Changing the Voice sensitivity: This parameter allows
adjustment of the sensitivity to voice. Higher numbers are
more sensitive. A typical value is in the range 3 to 4.
3.1.
Follow section 1 above to enter and work in Setup
mode.
3.2.
Use the [ ] + [ ] keys combination to access the voice
sensitivity adjustment. Voice Sensitivity values are
Typically:
3.2.1.
For very high sensitivity, set to values 4 or 5.
The down side is the unit will also be sensitive to
noise and may throw targets on any speech
sound and some gunshot echoes.
3.2.2.
For average sensitivity, set to 3. This will reduce
sensitivity to noise. This is the recommended
value for use with TargetManager.
3.2.3.
Set to 1-2 in very noisy environment including
gunshots echoes from nearby fields. Shooter will
need to call loud and long “Pull”.