E
E
Z
Z
P
P
u
u
l
l
l
l
T
T
r
r
a
a
p
p
S
S
e
e
t
t
u
u
p
p
&
&
P
P
a
a
i
i
r
r
i
i
n
n
g
g
G
G
u
u
i
i
d
d
e
e
For TRBP-02 (HW 2.5.0)
EZPull Trap is a voice activated, wireless clay target release
system for Trap.
EZPull Trap has special Setup and Pairing modes intended only
for the Gun Club’s administrator.
Warning: Always stand clear of any traps that may be activated
by EZPull.
1.
Using Setup Mode: The Setup mode provides access to
parameters that determine the operation of the device.
1.1.
Enter Setup Mode: Remove the rubber boot. Remove
the battery door. Remove one battery. Press and hold
setup “wrench” [ ] key and replace the battery. When
both lights are on steady, release the key. The lights
will alternate slowly indicating the unit is in Setup mode.
1.2.
Exit Setup Mode: When in Setup mode, press and hold
the “Target” [ ] and “Speaker” [ ] keys
simultaneously. Both lights will turn on steady. Release
the keys. Unit will go directly to release mode ready to
release targets on key press/Voice.
1.3.
Access Setup Adjustment: pressing and holding any two
key combinations simultaneously, (except [ ] + [ ])
will result in both lights flashing rapidly. Keep holding
the keys until both lights are turned off. Then release
the keys. The setup parameter’s current numeric value
will be indicated by the LEDs.
1.4.
Understanding the numbering indicators:
1.4.1.
Each parameter can be set to numbers in the
range 1 to a maximum value specific to the
parameter but never more than 16.
1.4.2.
The left LED indicates the “tens” digit.
1.4.3.
The right LED blinks the number of times
corresponding to the “ones” digit
1.4.4.
Examples:
Number 06: left light is off; right light blinks 6
times.
Number 14: left light is on; right light blinks 4
times.
1.5.
Adjusting the Number:
1.5.1.
Increase: for the next value, press and quickly
release the “Speaker” [ ] key. The operation is
cyclical, after you reach the maximum value, the
next number is #1.
1.5.2.
Decrease: for the previous value, press and
quickly release the “Target” [ ] key. The
operation is cyclical, after you reach #1, the next
number is the maximum value.
1.5.3.
Verify: After each key press, observe the lights
to verify the number.
1.6.
Exit adjustment: Once you verify the correct value,
press the “ON/OFF” [ ] key to save and return to Setup
mode or press the “wrench” [ ] key to exit without
saving any changes.