Installation:
<Mounting the controller>
1. Make a 1.77 x 1.77" (45 x 45 mm) panel cutout (1/8" to 3/8" thickness)
2. Slide the controller into the cutout until the bezel is flush with the panel.
3. Slide the mounting bracket over the rear of the controller and press snugly against the
rear of the panel.
<Rear panel connection>
Connect the alarm/control devices to the HI or LO relay terminals.
The SPDT relays are dry contact type and the terminal designations are:
C
: Common,
NO
: Normally Open,
NC
: Normally Closed
