EZiclean Hobot 2S, Руководство пользователя

Страница: 10 / 12

10
FR - EN
- Follow the instructions above to detach the tank.
- Slightly lift the back of the plastic cover around the spray nozzle and separate the plastic cover from the water tank.
- Slightly lift the silicone ring and separate it from the water tank. Do not press on the welding point and / or the ultrasonic nozzle.
- Place the new ultrasonic spray nozzle on the water tank, make sure the connection cable is aligned with the bottom edge of the water
tank, then install the bottom of the silicone ring on the water tank. ‘water.
- Press the silicone ring to secure it, then using another finger, lightly push the top of the silicone ring into the water tank.
- Check that the new ultrasonic spray nozzle is properly fitted to the water tank.
- Leave the connection cable through the hole on the plastic cover and return the front face of the plastic cover to its original position.
- Connect the new water tank to the robot and slide the tank back, then tighten the screw.
Maintenance frequency: When the ultrasonic nozzle is clogged and cannot spray water.
Contact a local or brand dealer for other spare parts.
4. Nettoyer les capteurs laser / Clean laser sensors
- Utiliser un chiffon doux propre et sec pour nettoyer deux capteurs. Fréquence d’entretien : Avant chaque utilisation.
- Use a clean, dry soft cloth to clean two sensors. Maintenance frequency: Before each use.
5. Nettoyer les roues chenilles / Clean the crawler wheels
Pour éviter que le robot ne glisse, essuyer la poussière accumulée des
courroies de chenille.
- Retourner le robot.
- Allumer l’interrupteur d’alimentation, les courroies chenilles du robot
fonctionneront continuellement pendant 3 minutes.
- Utiliser un chiffon pour nettoyer les courroies de chenille et garder le
chiffon au milieu des courroies pour éviter qu’il ne se coince. Si le tissu
est coincé, mettre le robot hors tension et tirer légèrement.
To prevent the robot from slipping, wipe the accumulated dust from the
crawler belts.
- Turn the robot over.
- Turn on the power switch, the robot crawler belts will run continuously
for 3 minutes.
- Use a rag to clean the track belts and keep the rag in the middle of the
belts to prevent it from getting stuck. If the fabric is stuck, turn off the
robot and pull lightly.
---HOBOT---