
eZi-DA66 Installation Manual
Revision 1.2
Page
9
KEYPAD WIRING
IMPORTANT: Use a screwdriver to install the keypad.
Using a power drill can damage the keypad.
The Multizone Controller keypad should be mounted in an electrical back box using a screwdriver to tighten. Do not use a power drill to tighten the keypad
screws. Over tightening can damage the keypad.
Use a good quality Cat5e/6 cable and crimp RJ45 jacks on each end of the cables. The RJ45 jack plugs into the back panel of the keypads and the 6 x RJ45
jacks on the keypad hub. The Multizone Controller keypad hub is included in your Multizone Controller kit. Plug the RJ45 jacks into any available jack on
the Multizone Controller keypad hub. Zone assignment is determined by the MODE dip switches on the back of the Multizone Controller keypad.
Zone Keypad
CAT5e/6 +/- 200m per run
CAT5e/6 Keypad Hub +/-5m
Keypad Hub