Ezgo ST 400 48V, Руководство пользователя и сервисное руководство

Страница: 26 / 55

OPERATION AND SERVICE INFORMATION
Page 11
Owner’s Manual and Service Guide
Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
anchored to floor. Wear OSHA approved safety
equipment when mounting/demounting tires.
If the tire is to be removed or mounted, the tire changing
machine manufacturer’s recommendations must be fol-
lowed in order to reduce possibility of severe injury.
Wheel Installation
To reduce the possibility of component damage, do not
tighten lug nuts to more than 85 ft. lbs. (115 Nm) torque.
It is important to follow the ‘cross sequence’ pattern when
installing lug nuts. This will assure even seating of the wheel
against the hub.
With the valve stem to the outside, mount the wheel onto
the hub with lug nuts. Finger tighten lug nuts in a ‘cross
sequence’ pattern (Ref Fig. 10 on page 11). Tighten lug
nuts to 50 - 85 ft. lbs. (70 - 115 Nm) torque in 20 ft. lbs.
(30 Nm) increments following the ‘cross sequence’ pat-
tern.
Fig. 10 Wheel Installation
LIGHT BULB REPLACEMENT
To reduce the possibility of premature bulb failure, do not
touch new bulbs with bare fingers. Use clean, dry tissue
or paper towel to handle the glass portion of the bulb.
For vehicles with headlights mounted in cowl, locate the
two screws on backside of cowl that secure headlight
(Ref Fig. 11 on page 11). Remove screws, pull headlight
out and disconnect wires. Connect wires to new head-
light, install in cowl and secure with screws previously
removed.
Fig. 11 Headlight and Turn Signal Bulb Replacement
To replace the turn signal light bulb, support turn signal
housing from backside of cowl while removing two
screws securing lens. Install new bulb and replace lens.
To replace the tail and brake light bulb, roll the rubber
bezel from around the edge of the taillight and remove
lens. Install replacement bulb and replace lens.
Fig. 12 Tail and Brake Light Bulb Replacement
FUSE REPLACEMENT
To replace fuses, locate the fuse block under the driver
side seat. Pull out old fuse and replace with a new auto-
motive type fuse. Headlight and taillight bulbs and fuses
Tire/wheel style
may vary
1
2
3
4
'Cross Sequence' 'Cross Sequence'
1
2 5
Ref Whi 2
3 4
Headlight
Bulb
Turn Signal Lens
Turn Signal
Housing
Inside
of Cowl
Ref Hdr 2
Rear
Fender
Tail/Brake
Light
Roll Rubber
Bezel Away
From Body
Ref Tlr 2