Ezgo FLEET RXV ELITE, Руководство пользователя

Страница: 34 / 56

26
M
AINTENANCE
Taillight
Make sure the vehicle key switch is in the OFF posi-
tion and the key has been removed from the switch.
1.
Remove two Phillips head screws that secure the
lens to the taillight assembly.
2. Remove the light bulb.
3. Install the new light bulb.
4. Install the lens and secure the lens with two Phil-
lips head screws.
FUSE REPLACEMENT
The fuse block is located on the fender liner on the driver side of
the vehicle. To replace a fuse, raise the seat bottom and locate
the blown fuse. Remove the old fuse and replace with a new fuse
of the same type and size
SYSTEM TEST
At monthly intervals, test the controller by allowing the vehicle to
roll down an incline with the accelerator pedal released. Braking
force should be felt at approximately 2 mph (3 kph) indicating
that the system is functioning. If vehicle speed continues to rise,
apply the service brake and have vehicle inspected by a trained
mechanic
REAR AXLE
The only maintenance necessary for the first five years is the
inspection of the rear axle for lubricant leakage. Unless leakage
is visible, the lubricant needs to be replaced after five years. Refer to the Repair Manual for the fluid replacement pro-
cedure.
Change the axle oil at the intervals indicated in the
SCHEDULED MAINTENANCE CHART on page 20. The drain
plug is located at the bottom of the rear axle housing.
Checking Lubricant Level
Clean the area around the check/fill plug and remove plug. The correct
lubricant level is just below the bottom of the threaded hole. If lubricant
is low, add lubricant as required. Add lubricant slowly until lubricant
starts to seep from the hole. Install the check/fill plug. In the event that
the lubricant is to be replaced, the oil pan must be removed or the oil
siphoned through the check/fill hole
Rear Fender
Lens
Bulb
Fuse Block
Check/Fill Plug