Ezgo FLEET RXV ELITE, Руководство пользователя

Страница: 33 / 56

M
AINTENANCE
25
Wheel Installation
NOTICE: To decrease the risk of component damage, do not tighten the lug nuts
to more than the specified torque.
Always install lug nuts using a cross sequence pattern to ensure even
seating of the wheel against the hub.
1. Install the wheel on the hub with lug nuts. Make sure the valve stem is to the out-
side.
2. Finger tighten the lug nuts.
3. Using the tightening pattern shown at right, tighten the lug nuts to 50 - 85 ft.lbs. (68
- 115 Nm) . Tighten in increments of 20 ft. lbs. (27 Nm).
LIGHTS
• Clean the lights frequently to maximize visibility.
• Replace burned out bulbs promptly.
Do not operate this vehicle at night or in low light if any bulbs are burned out. Poor light-
ing reduces visibility that could cause an accident resulting in severe injury or death.
NOTICE: Replacement bulbs are available from a local Distributor, an authorized Branch or the Service Parts
Department.
Headlight Replacement
Light components can get hot if they have been in operation. Allow the lights to cool
before servicing to prevent burns to the skin.
NOTICE: Do not touch a halogen bulb with bare fingers. Oil from skin leaves a reside that causes a hot spot
and will diminish the life of the bulb.
Make sure the vehicle key switch is
in the OFF position and the key has
been removed from the switch.
1.
Pull the locking ring straight off
the back of the light housing
and allow it to slide down the
harness and out of the way.
2. Rotate the bulb socket
counter-clockwise and pull to
remove the bulb and socket.
3. Pull the bulb out of the socket.
4. Insert the new bulb into the
socket
5. Install the new bulb and socket
into the headlight opening and
rotate the socket a quarter turn
clockwise to secure it in the
housing.
6. Slide the locking ring over the socket and onto the back of the housing.
Turn Signal (if equipped)
Make sure the vehicle key switch is in the OFF position and the key has been removed from the switch.
1.
Rotate the bulb socket a quarter turn counter-clockwise to unlock it. Pull the socket and bulb out of the housing.
2. Remove the turn signal bulb from the housing socket and install a new bulb.
3. Align the turn signal housing with the opening in the back of the light assembly, turn the housing a quarter turn
clockwise to secure it.
Lug Nut Torque 50 - 85 ft.lbs. (68 - 115 Nm)
Lug Nut Tightening Pattern
Turn Signal
Bulb
Headlight
Bulb