OPERATION AND SERVICE INFORMATION
Page 15
Owner’s Manual and Service Guide
Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
TIRE INSPECTION
Tire condition should be inspected per the Periodic Ser-
vice Schedule (Ref. Fig. 16 on page 14). Inflation pres-
sures should be checked when the tires are cool. Be sure
to install the valve dust cap after checking or inflating.
CHECKING THE OIL LEVEL
Do not overfill engine. Too much oil may cause engine to
smoke or spark plug fouling.
.
When adding oil between oil changes, do not mix brands and
viscosity grades of oil. Both the oil dipstick and fill cap must be
in place before operating the engine. Failure to install the dip-
stick and fill cap will result in oil becoming contaminated and/or
oil being discharged into the engine compartment.
FUEL SYSTEM
9
Check for leaks at tank, cap, system lines, filters, pump, carburetor
9
Check system lines for cracks/deterioration
THROTTLE/GOVERNOR LINKAGE
9
Check operation and governed speed
HARDWARE AND FASTENERS
9
Check for loose or missing hardware and components
Tighten or replace missing hardware
SEMI-ANNUAL - 125 HOURS
(includes items listed in previous tables & the following)
BATTERY
Clean battery & terminals
DIRECTION SELECTOR
9
Check for wear and smooth movement (lubricate shaft with light oil if required)
KING PINS
9
Check for excessive play and tightness of retaining nuts
STEERING ASSEMBLY
9
Check bellows and pinion seal for damage or grease leakage
RACK END BALL JOINT
Lubricate, use wheel bearing grease
REAR AXLE
9
Check for unusual noise and loose or missing mounting hardware
AIR FILTER ELEMENT
9
Check filter element, clean/replace as required
OIL FILTER
Clean in solvent (at oil change), replace ‘O’ rings if required
ENGINE OIL
S
Replace with SAE 10W-30 or 10W-40 that meets or exceeds SF, SG, CC oil,
DO NOT OVERFILL
DRIVE BELT
9
Check for cracks, fraying and excessive wear
ANNUAL - 250-300 HOURS
(includes items listed in previous tables & the following)
FRONT WHEEL BEARINGS
9
Check and adjust as required, see Technician’s Repair and Service Manual
REAR AXLE
9
Check lubricant, add lubricant (Ref Fig. 37 on page 23) as required
SERVICE BRAKES
Clean and adjust, see Technician’s Repair and Service Manual
9
Check brake shoe linings, see Technician’s Repair and Service Manual
9
Check level, add if required (DOT 3) and check for leakage
FUEL FILTER
Replace
SPARK PLUGS
Replace, gap new plugs (Ref Fig. 37 on page 23)
MUFFLER/EXHAUST
9
Check mounting hardware; check for leaks at head and muffler gaskets
VALVES
9
Check cold (intake/exhaust) per Technician’s Repair and Service Manual
500 HOURS
(includes items listed in previous tables & the following)
TIMING BELT
9
Check tension and for signs of wear/damage, replace if worn or damaged
CARBURETOR
Clean
CYLINDER HEAD AND PISTONS
Remove carbon from cylinder head and pistons
9
Check valve seats for carbon buildup and clean as required
Fig. 16 Periodic Service Schedule
Содержание 605584-DK
