Troubleshooting
1 Power
Faulty connection of
joystick and the motor
connector
Re-plug the 4 – pin plug
into the battery connector
at the side of the chair;
refer to instructions on
Page 16.
Low power supply, the
power cut off automatically
If the power is off
automatically, the batteries
must be recharged within
2 hrs, and charged for 10-
12 hrs, refer to instructions
on Page 23 and 24.
Fault of the 3-pin plug
connecting to the battery
Pull out the battery and
check the contact for any
fault and re-insert the
battery. Refer to
instructions on Page 22 &
23.
2 LED light flashes
The lowest level LED light
flashes: low battery power.
Recharge the batteries
immediately.
The second level LED light
flashes: the control panel
failing to deliver control
signal
Reconnect the plugs of the
two ends of the control
panel cable, or replace the
joystick.
The third level LED light
flashes: the batteries are
being charged chair from
operating when batteries
Do not use the chair, An
electronic drive locking
device preventing the are
being charged.
The fourth level LED light
flashes: motor connection
failed.
Re-plug and tighten the
motor connector
3
Electromagnetic
brake
The fifth level LED light
flashes: The
electromagnetic brake is in
“Unlock” Position and the
chair will not move
Push the electromagnetic
brake lever to “Lock”
position, please refer to
instructions on Page 20.
When the power is off, and
the electromagnetic brake
lever is in “Lock” position,
the motor wheels can
move freely.
Contact the customer
service to replace the
electromagnetic brake.
32