When the LED light flashes intermittently, which indicate speci fic diagnostic
troubles referred in the table below:
Joystick
When operating the chair for the first time, it is recommended to move the chair
at a low speed gently and gradually pushing the control joystick forward. The
practice run will help you familiarize yourself with controlling the speed and start
and stop of the chair.
Do not do sharp turns at high speeds. The chair will lose its balance and tip
over causing serious bodily injury and property damage.
The control joystick on the control panel provides 360 degrees of omnibearing
maneuver ability comfortably and effortlessly. A spring is equipped inside the
joystick which automatically returns to its original position when let go.
Push the joystick towards the target direction. The joystick can control the drive
proportionally, the harder the push, the faster it goes. The max traveling speed
is 6km/hr.
Release the control joystick slowly and gradually for the chair to slow down
safely. Sudden release of the control joystick may cause the chair to lose
balance and tip over causing bodily injury.
15
The fourth LED light flashes: Motor connection failed
The lowest LED light flashes: Batteries are running
low
The second LED light flashes: Joystick cannot deliver
signals to the control module
The third LED light flashes: Batteries are being
charged. Note: An electronic drive locking device is
engaged to prevent the chair from operating.
The fifth LED light flashes: Electromagnetic braking
disengaged
