The EZ Lift requires a minimum of servicing to keep it in good working order. Nevertheless, it is important
that certain basic checks be periodically made by maintenance staff to ensure on-going safety throughout the
life of the device.
The manufacturer suggests that the following components and operating points be scheduled for inspection
at intervals not greater than one month. Any detected deficiency must be rectified before the lift is put
back into service.
1. Check wear of hanger assembly bushing by moving hanger assembly up and down.
If hanger assembly moves up and down and the thickness of 2 quarters can be inserted
between hanger assembly and load cell the hanger assembly needs to be replaced.
2. Check all bolts to ensure they are tight.
3. Check boom to hanger assembly pivot bolt, peel rubber back to assure
nut is tight and cotter pin is in place. Check boom to mast pivot bolt
by removing plastic cap to assure nut is tight and cotter pin is in place.
If plastic cap is missing order replacement.
4. Check the point where sling hanger and hanger spreader bar meet. If excessively worn,
replace the bushings immediately. The hanger spreader and sling hanger wear points
need to be checked for wear. If hooks appear worn, call EZ Way for instructions.
5. Check mounting bolts of actuator top and bottom. Pay particular
attention to top bolt hole for elongation.
(Continued on Reverse)
EZ Way, Inc.
1,000 lb. EZ Lift Safety & Maintenance Checklist
Form 1-131
Rev. 4/14/08
BASE PIVOT REAR WHEEL FRONT WHEELS LINKAGE SPREADER
TOP OF
ACTUATOR
BADLY WORN
NEEDS REPLACEMENT
BOOM TO MAST
BOOM TO HANGER
ELONGATED
BOTTOM OF
ACTUATOR
