Page
2
of
3
This supplement covers the special requirements for installing the Fortress Stair System Canopy. For
additional instructions, refer to the main manual titled
Fortress OSHA Stair System Adjustable Stair
Installation Manual.
1.
SAFETY AND WARNINGS
WARNING!
Rated load is 100 psf, 300 lbs. concentrated. Never exceed rated load.
Regularly check for damage and tighten any loose fasteners.
Keep canopy clear of ice, snow, dirt, leaves and other debris at all times.
Re-read your
Fortress OSHA Stair System Adjustable Temporary Stair Manual
before installing the Canopy and
follow all warnings, maintenance, and safety information.
Do not use the system without properly installed handrails.
Periodically inspect and confirm all parts of the canopy are in good condition, correctly positioned, and securely
fastened. If damaged, loose, or missing parts are noted, DO NOT USE and contact manufacturer.
Regularly check and properly tighten fasteners as needed.
Metal conducts electricity. Never use near electrical current.
Use caution at all times. Do not run or jump on the system.
Do not use any part of the system, including handrails, to support planters, power cords, decorations, etc.
2.
INSTALLATION TOOLS
Tape measure
9/16” wrench
Level
9/16” socket
Ratchet wrench
1/2” wrench
Marker
1/2” s
ocket
3.
INSTALLATION:
3.1.
Remove handrails from Fortress OSHA Stair System, if installed, and set aside.
WARNING!
Use extreme caution on platform when handrails are removed.
3.2.
Insert
1 1/2”
square canopy posts into platform corner pockets with the holes oriented toward the platform. The
canopy corner post, the only one with holes on all four sides, must be in the corner where the two handrails will
connect. Orient the two canopy posts at 90° from the corner post so the holes are in line with the holes in the
corner post (FIG. 1).
3.3.
Set canopy roof on canopy posts. Insert top of canopy posts into canopy roof corner pockets and tighten
corner pocket set screws (FIG. 1).
3.4.
Insert 5/16”
-18 x 3-
1/2” button head socket cap screws
,
5/16” flat
washers, and
5/16”
-18 locknuts as shown
(with the locknuts on the inside) to attach handrails to the canopy posts. Tighten all fasteners securely (FIG. 2).
3.5.
Install
1/4” x 1” pan head Phillips
self-tapping screws through the existing holes in the platform corner pockets
into the 1 1/2”
square canopy posts (FIG. 2). Pre-
drill 1/8” pilot holes in the canopy posts if needed.
3.6.
Make sure all fasteners are in place and tightened securely. Regularly check and tighten
fasteners as needed.
Содержание Fortress OSHA
Страница 3: ...Page 3 of 3 FIG 1 FIG 2...
