Eyyes CarEye Safety Angle, Руководство по установке, Страница: 24 / 32

WWW.EYYES.COM
CAREYE
®
SAFETY ANGLE - TURN - ASSIST
INSTALLATION AND INSTRUCTION MANUAL
24 D
Electrical connection
IMPORTANT NOTES
The CAREYE ® SAFETY ANGLE system or its components must
be installed and wired in such a way that they start up
automatically when the ignition is switched on. Under no
circumstances may the entire system or parts of it be
switched off or implemented.
!
Only use the cables supplied, special lengths are available if
required.
Do not shorten or extend any cables with the exception of
the cable for the power supply and the steering angle
sensor.
Make sure that the cables are secured against pulling, if
necessary tie them together with cable ties to provide
strain relief.
Avoid drilling holes with sharp burrs and make sure that
the cables do not rub against sharp edges.
When laying the cables, take care not to crush or otherwise
damage them.
Protect the cables from sharp edges and corners and do
not lay them over them.
Observe the minimum bending radius of the cables and do
not go below 7.5 times the outer diameter of each cable.
Do not expose the cabling to heat or aggressive substances
such as oils or fuels. Replace defective, damaged or kinked
cables immediately.
Operate only the intended and supplied components and
devices in the CAREYE
® SAFETY ANGLE system.
!!