SETTING UP YOUR BEAM
If needed, it's possible to slightly adjust
the projection position after installing
the device.
Release the
mirror's
Hex / Allen screws
and gently nudge it to
tilt
the projection
back or forth.
If the projection is
skewed
, straighten it by clicking
the
menu
button on your projection
remote
, then
Settings
, and select to adjust the
Keystones
.
Note that after adjusting the keystones, the projection
must be
calibrated
(calibration is available in the
Settings section in the control area).
Set up the projection are so it will cover the
table
you aim to project
on
entirly
.
If that's not possible due to the ceiling height or zoom limitation, try
to cover as much of the table's surface as possible.
TABLE PLACEMENT IN PROJECTION AREA
