Exxentric kPulley Go, Руководство пользователя, Страница: 11 / 20

11
kPulley Go Manual v1.2.1 Introduction
The Flywheel
We offer five differently sized flywheels with inertia: 0.005,
0.010, 0.025, 0.050 and 0.070 kgm
2
.
All flywheels from the kBox4 generation are compatible with the
kPulley. The kPulley can hold a maximum of 2 flywheels at a time.
This allows for a range of inertia between 0.005 and 0.140 kgm
2
.
Do not try to mount more than the maximum capacity of
flywheels.
Experimentation will determine which configuration is required for
your level of training. Mounting or changing flywheels is done by
releasing the flywheel knob by pulling the pull pin knob on its side,
removing the flywheel knob, changing flywheel(s) and securing
them by pushing the flywheel knob back on until it makes a clicking
noise.
Tip: If the black pull pin knob is hard to pull out, you can push the
flywheel knob in whilst pulling the black pull pin knob out.
INTRODUCTION
Setting up the
kPulley Go
Flywheel Protection
The kPulley Go beam must be firmly fixed in place. Use the
holes in the center of the beam or fix using a strong belt in
the metal brackets on the back of the beam.
We recommend having the flywheel protection attached
to the kPulley Go, in order to protect the user from injury.
Flywheel Knob
Pull Pin Knob