extronics iTAG, Руководство по эксплуатации

Страница: 12 / 20

12
Figure 5.1
5.1.2 Installing on a wall
The Multicharger should not be installed at a height exceeding 2m from the top edge.
Mark out the screw hole patterns as per the preferred configurations and drill a hole to
accommodate the wall plugs supplied. Insert the wall plugs into the drilled holes. All
holes should be drilled to avoid damaging the Multichargers.
If daisy chaining the Multicharger insert the daisy chain and mains cable into the rear
of the Multicharger. If a single Multicharger do not fit or purchase a daisy chain cable.
It is
preferable to retain the cables using the ‘clip’ features.
Check that the screws and wall plugs provided are suitable for the chosen wall.
Alternative screws or wall plugs may need to be used. If suitable, using the screws
provided, insert them into the
Multicharger’s mounting holes and offer the Multicharger
to the wall. Screw the screws into the wall plugs until the screw fully bottoms out inside
the Multicharger.